STRAKES. Bulkheads/Baffles Installation #3

strakesbulkheadsbafflesinstallation3.jpg

I measured some of the templates and found that most were bigger than necessary but some seemed to be shorter than required to cover for the necessary angles between the parts. In this regard, I decided to make my own templates with cardboard to reduce the building time and avoid the cumbersome fitting process described in the manual. See #8 on Related Projects/Ideas section "METHOD TO MAKE FUEL STRAKES BULKHEAD/BAFFLES" for a detailed explanation of the process used. I cut the parts from the templates, trimmed them, opened the mouse holes and sealed them by removing foam from the edges and replacing it with micro.

Photo album created with Web Album Generator