COOLING PLENUM CHAMBER. Air Intake SCAT Hose #1

coolingplenumchamberairintakescathose1.jpg

My air fuel servo intake is four inches in diameter, as opposed to the more common three inches. Therefore, I had to make a four-inch round fiberglass cylinder to use as the base for the flanges to attach the SCAT hose. I could not find an exact diameter container around the house to make it, so I decided to make one slightly larger and then adjust it to the right size. I used a 4-inch cylindrical plastic container, covered it with duct tape, a thin film of petroleum jelly and laid three layers of BID with peel–ply over it to make a tube about 5.5 inches long.

Photo album created with Web Album Generator